Hi all; I'm working with a PPC 460EX-based board. I have a 2.6.25.10-based kernel I obtained from the DENX git tree which contains a port to this board, under arch/powerpc.
I can build a kernel and have it downloaded and booting using u-boot, providing the blob and appropriate kernel parameters, after having done a standard "make zImage" with the appropriate configs etc. All good so far. However, my ultimate target board uses a custom bootloader, not uboot, which is very, very simple (please don't suggest we just switch to uboot--that argument has been already had, and lost :-/) I had a previous version of Linux, 2.6.14, booting on a predecessor of this board based on the 440GX with the same bootloader, but the creation of that image was done under arch/ppc and it was pretty different (I'm discovering). And, I didn't do that port anyway. Anyway, I need to generate an all-in-one image containing the kernel and the initrd, and the trampoline code tacked onto it to turn it into an ELF image. I'm worried I'll need to write a custom platform_init() but for now I'm just using of.c. >From what I can tell, the wrapper script seems to be intended to have the ability to generate an image like this. I've tried just running "make zImage.initrd" after putting the ramdisk.initrd.gz in the right place, and it seems to create an image OK: using file shows it to be "ELF 32-bit MSB executable, PowerPC or cisco 4500, version 1 (SYSV), statically linked, not stripped", which seems correct. But we can't get it to boot. The bootloader downloads the image (tftp) and jumps to the start address in the ELF image, and immediately takes an illegal instruction. We have set the bootloader to load the image at 0x00000000 and then we look through the ELF image for the start address, which (using objdump) I can see is the correct address for the _zimage_start symbol from crt0.S; in our case it's 0x00400204. When we use a debugger to look at what's loaded at that location, it's just a whole slew of 0xa bytes... obviously not right. Is the start address not the offset from the start of the ELF image? Should we be loading the image somewhere else (the previous incarnation loaded it at 0x0, so we just did that too)? I'm afraid I'm at the very outer limits of my knowledge on these matters. I realize there is not enough detail in the above to really provide an answer but any suggestions anyone has would be very much appreciated. Cheers! _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded