I sort of made some progress by changing the NIC:

ethtool -i eth1
driver: e1000e
version: 2.3.2-k
firmware-version: 0.13-4
bus-info: 0000:00:19.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: no

ethtool -T eth1
Time stamping parameters for eth1:
Capabilities:
    hardware-transmit     (SOF_TIMESTAMPING_TX_HARDWARE)
    software-transmit     (SOF_TIMESTAMPING_TX_SOFTWARE)
    hardware-receive      (SOF_TIMESTAMPING_RX_HARDWARE)
    software-receive      (SOF_TIMESTAMPING_RX_SOFTWARE)
    software-system-clock (SOF_TIMESTAMPING_SOFTWARE)
    hardware-raw-clock    (SOF_TIMESTAMPING_RAW_HARDWARE)
PTP Hardware Clock: 1
Hardware Transmit Timestamp Modes:
    off                   (HWTSTAMP_TX_OFF)
    on                    (HWTSTAMP_TX_ON)
Hardware Receive Filter Modes:
    none                  (HWTSTAMP_FILTER_NONE)
    all                   (HWTSTAMP_FILTER_ALL)
    ptpv1-l4-sync         (HWTSTAMP_FILTER_PTP_V1_L4_SYNC)
    ptpv1-l4-delay-req    (HWTSTAMP_FILTER_PTP_V1_L4_DELAY_REQ)
    ptpv2-l4-sync         (HWTSTAMP_FILTER_PTP_V2_L4_SYNC)
    ptpv2-l4-delay-req    (HWTSTAMP_FILTER_PTP_V2_L4_DELAY_REQ)
    ptpv2-l2-sync         (HWTSTAMP_FILTER_PTP_V2_L2_SYNC)
    ptpv2-l2-delay-req    (HWTSTAMP_FILTER_PTP_V2_L2_DELAY_REQ)
    ptpv2-event           (HWTSTAMP_FILTER_PTP_V2_EVENT)
    ptpv2-sync            (HWTSTAMP_FILTER_PTP_V2_SYNC)
    ptpv2-delay-req       (HWTSTAMP_FILTER_PTP_V2_DELAY_REQ)



I use this config file:
[global]
verbose               1
time_stamping         software
tx_timestamp_timeout  1000

and when I run  *sudo ptp4l -i eth1 -f /etc/ptp4l.conf*   I get:
ptp4l[519792.941]: port 1: INITIALIZING to LISTENING on INITIALIZE
ptp4l[519792.941]: port 0: INITIALIZING to LISTENING on INITIALIZE
ptp4l[519799.549]: port 1: LISTENING to MASTER on
ANNOUNCE_RECEIPT_TIMEOUT_EXPIRES
ptp4l[519799.549]: selected best master clock 002590.fffe.f2c1e4
ptp4l[519799.549]: assuming the grand master role


After this it seams to just...hang; there no other activity.  Any ideas?

Thanks,
Andrei



On Mon, Jun 16, 2014 at 5:49 PM, Richard Cochran <richardcoch...@gmail.com>
wrote:

> On Mon, Jun 16, 2014 at 06:46:07PM +0200, Richard Cochran wrote:
> >
> > uname -a ?
>
> Also,
>
>    ethtool -T eth0
>    ethtool -i eth0
>
> Thanks,
> Richard
>

-- 
 

The information transmitted is intended only for the person or entity to 
which it is addressed and may contain confidential and/or privileged 
material. Any review, retransmission, dissemination or other use of or 
taking of any action in reliance upon this information by persons or 
entities other than the intended recipient is prohibited. If you receive 
this in error please contact the sender and delete the material from any 
computer immediately. It is the policy of Klas  Limited to disavow the 
sending of offensive material and should you consider that the material 
contained in the message is offensive you should contact the sender 
immediately and also your I.T. Manager.

Klas Telecom Inc., a Virginia Corporation with offices at 1101 30th St. NW, 
Washington, DC 20007.

Klas Limited (Company Number 163303) trading as Klas Telecom, an Irish 
Limited Liability Company, with its registered office at Fourth Floor, One 
Kilmainham Square, Inchicore Road, Kilmainham, Dublin 8, Ireland.
------------------------------------------------------------------------------
HPCC Systems Open Source Big Data Platform from LexisNexis Risk Solutions
Find What Matters Most in Your Big Data with HPCC Systems
Open Source. Fast. Scalable. Simple. Ideal for Dirty Data.
Leverages Graph Analysis for Fast Processing & Easy Data Exploration
http://p.sf.net/sfu/hpccsystems
_______________________________________________
Linuxptp-devel mailing list
Linuxptp-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linuxptp-devel

Reply via email to