The following errata report has been submitted for RFC9303, "Locator/ID Separation Protocol Security (LISP-SEC)"
-------------------------------------- You may review the report below and at: https://errata.rfc-editor.org/eid9275/ -------------------------------------- Type: Technical Reported by: Wenbin Zhou <[email protected]> Section 6.1 says: Original Text ------------- OTK Length: The length (in bytes) of the OTK Authentication Data (OTK-AD), which contains the OTK Preamble and the OTK. Corrected Text -------------- OTK Length: The length (in bytes) of the OTK Authentication Data (OTK-AD), which contains the OTK Length, Key ID, and OTK Wrapping ID fields, followed by the OTK Preamble and the One-Time Key. Notes ----- Figure 1 draws the OTK-AD as covering the OTK Length, Key ID, and OTK Wrapping ID fields as well as the OTK Preamble and the One-Time Key, but this definition says that the OTK-AD contains only the OTK Preamble and the OTK. The EID-AD follows the other convention: Section 6.4 sets the EID-AD Length to 4 bytes when it contains only the 2-byte KDF ID field, and Section 6.9 measures the EID-AD from the EID-AD Length field. With a 128-bit OTK the definition yields 24 bytes while Figure 1 yields 28 bytes, which changes where the receiver locates the start of the EID-AD. The correction aligns the definition with Figure 1 and with the EID-AD convention. Instructions: ------------- This erratum is currently posted as "Reported". Please use "Reply All" to discuss whether it should be verified or rejected. When a decision is reached, the verifying party will log in to change the status and edit the report, if necessary. -------------------------------------- RFC9303 (draft-ietf-lisp-sec) -------------------------------------- Title : Locator/ID Separation Protocol Security (LISP-SEC) Publication Date : October 2022 Author(s) : F. Maino, V. Ermagan, A. Cabellos, D. Saucez Category : Proposed Standard Source : lisp (rtg) Stream : IETF Verifying Party : IESG _______________________________________________ lisp mailing list -- [email protected] To unsubscribe send an email to [email protected]
