hi all, so, for some odd reason, the natting rules were not created.
i went Firewall -> NAT -> Outbound selected Manual and created a general rule for the WAN interface. perfect. thanks! m On Wed, 2013-06-26 at 13:54 +0300, Odhiambo Washington wrote: > I suspect that you just haven't configured pfSense properly for I am > running the same version inside vmware virtual machine and all is > working fine. > My interfaces are configured in bridge mode. > > > On 26 June 2013 12:44, mayak-cq <ma...@australsat.com> wrote: > > Hi All, > > I have a freshly installed 2.1 RC candidate installed on a > vmware virtual machine ... > > After doing basic setup, I tried pinging a host on the > internet -- no response -- finally went into pfsense and did a > tcpdump on the wan interface -- packets are being sent out the > wan interface with the lan host address. > > Why would that happen? > > Thanks > > M > > _______________________________________________ > List mailing list > List@lists.pfsense.org > http://lists.pfsense.org/mailman/listinfo/list > > > > > > > -- > Best regards, > Odhiambo WASHINGTON, > Nairobi,KE > +254733744121/+254722743223 > "I can't hear you -- I'm using the scrambler." > > > _______________________________________________ > List mailing list > List@lists.pfsense.org > http://lists.pfsense.org/mailman/listinfo/list
_______________________________________________ List mailing list List@lists.pfsense.org http://lists.pfsense.org/mailman/listinfo/list