You could always write a new boot0 to your disk. If you load a FreeBSD disc and 
run the following command on your pfsense hard disk.

fdisk -B -b /boot/boot0 device

Where device is your pfsense drive.

This should do the trick.

Source: https://www.freebsd.org/doc/handbook/boot-introduction.html

Hope this helps!

-----Original Message-----
From: List [mailto:list-boun...@lists.pfsense.org] On Behalf Of Kostas Backas
Sent: Friday, June 30, 2017 6:17 AM
To: list@lists.pfsense.org; pfSense Support and Discussion Mailing List
Subject: Re: [pfSense] MBR restore

Maybe install a fresh version and restore a backup?

Kostas

Sent from my iPhone
________________________________
From: List <list-boun...@lists.pfsense.org> on behalf of Nicola Ferrari 
(#554252) <nick-li...@posteo.eu>
Sent: Friday, June 30, 2017 2:02:47 PM
To: list@lists.pfsense.org
Subject: [pfSense] MBR restore

Hi guys!

I'm writing here since one of my collegues had to move a pfsense install to new 
hardware, so imaged the pfsense using clonezilla but forgot to enable the 
option to save MBR also.

So, after restoring the image, pfSense is no more able to boot.

What's the best way to restore the MBR on an existing and already-configured 
pfSense install?

Thanks to everybody!
Nick


--
+---------------------+
| Linux User  #554252 |
+---------------------+

_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold 
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold

Reply via email to