I am trying to take a machine that is Legacy BIOS and switch it to UEFI during 
a bare metal install.  So take a machine out of the box and end up with a UEFI 
enabled, GPT partitioned, bitlockered, Windows 7sp1 x64 deployment (fully 
automated)


So the system boots in Legacy bios to a USB Stick with the WinPE 5.1 64bit boot 
image.  Then I am using Dell tools to switch the Firmware to UEFI mode.  Then I 
repartition the disk in the GPT format.  Then I want to reboot the task 
sequence to boot into UEFI mode from the newly GPT partitioned disk.  My 
problem is that "Restart Computer" task step refuses to stage the WinPE image 
on that GPT partitioned disk.

The error says that disk C: is on a GPT disk, but the system is MBR.  It is 
unable to see that I have just switched the Firmware to UEFI and so it is 
refusing to stage WinPE on that GPT partition.   I would have sworn I had this 
working, but now it is broken.  Can TSCore.dll be made to reevaluate the 
Firmware state so it can see that the Firmware has been switched to UEFI?

Any ideas on how to trick "Restart Computer" step into staging the WinPE image 
to the boot drive - even though it thinks the partitioning scheme is wrong?  It 
isn't realty wrong... if it would just stage it and reboot, it would boot OK.



SCCM 2012R2Cu4, OSD+MDT2013, deploying Windows 7sp1 x64, boot image is WinPE 
5.1 based.


My other solution would be to force the desktop support staff to go in an 
manually set the BIOS to UEFI mode and then restart the process, but that is 
unreliable since it is not automated.


________________________________
Notice: This UI Health Care e-mail (including attachments) is covered by the 
Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and 
may be legally privileged.  If you are not the intended recipient, you are 
hereby notified that any retention, dissemination, distribution, or copying of 
this communication is strictly prohibited.  Please reply to the sender that you 
have received the message in error, then delete it.  Thank you.
________________________________

Reply via email to