It works but you may want to wait 20-30 minutes this list has good
response and they may tell you how to set up the Log4j.xml file. I had
to "hack" it make it a panel so I could embed in my application and not
run as a standalone 

-----Original Message-----
From: Mark [mailto:[EMAIL PROTECTED] 
Sent: Wednesday, December 14, 2005 10:24 AM
To: Log4J Users List
Subject: Re: how to load a receiver upon Chainsaw startup

hrmm.  So you had to hack the code to get this to happen.  I have been
looking at the code, and it does not look like it would be tough to do.
Not sure what the status of the zero-config code is, but I will do the
same thing that you did.

Thanks.



On 12/14/05, Harp, George <[EMAIL PROTECTED]> wrote:
>
> With the old version of chainsaw I created a panel like the Jframe 
> example they had and then created the receiver first then the appender

> with a static method executed when the application started.
>
> -----Original Message-----
> From: Mark [mailto:[EMAIL PROTECTED]
> Sent: Wednesday, December 14, 2005 10:01 AM
> To: Log4J Users List; [EMAIL PROTECTED]
> Subject: how to load a receiver upon Chainsaw startup
>
> How can I load a Receiver upon startup of Chainsaw.  I do not want to 
> configure the receiver each time that I start Chainsaw.  If there is a

> way to have the receiver started when the Chainsaw GUI is shown, that 
> would be ideal !!
>
> TIA
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
>
>

---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]

Reply via email to