Hi Les,
> The new definitions in the latest version in the draft are very close to what > we discussed in the earlier thread – so this looks pretty good to me. Excellent, thanks. > I still have some concerns regarding the Area Segment SID. > You propose to advertise this in two places: > > 1)As a sub-TLV of the new Area Proxy TLV > 2)As a new sub-TLV of the existing Binding TLVs (149, 150) > > I am not sure why you need this in the Area Proxy TLV as you allow Binding > TLVs to be advertised in the Proxy LSPs (Section 4.4.10). > ??? Again, the subTLVs of the area proxy TLV are for the coordination of the Inside Area. The Area Proxy TLV appears in the Inside Node’s normal LSP. The Proxy LSP is for informing the Outside Area. It’s fairly important that we install the forwarding state for the Area Segment SID and distribute the Proxy System ID before we advertise the Proxy LSP. > If this is what is intended, it raises a number of concerns: > > If both are present and inconsistent how are they used? If both are present and inconsistent, then we have a major malfunction of the Area Leader, since it is the single system that is intentionally advertising both. The Inside Nodes would follow the contents of the Area Proxy TLV and employ one SID value. The Outsiide Nodes would follow the contents of the Proxy LSP and employ a different SID value. Hilarity ensues. Note that this is somewhat analogous to a system that wished to advertise a loopback interface and advertised one prefix into L1 and another prefix into L2. > As Area Proxy TLV does not support MT (not suggesting that it should) it > isn’t clear how this relates to MT context – which exists for TLVs 149/150. > > Encoding wise, if we are to support Area Segment SID in the Binding TLVs, I > think more detail needs to be provided as to flag settings when the new > sub-TLV is present. > The following flags are currently defined for the Binding TLVs: > > 0 1 2 3 4 5 6 7 > +-+-+-+-+-+-+-+-+ > |F|M|S|D|A| | > +-+-+-+-+-+-+-+-+ > > F,S,D flags seem applicable w/o change. > However, M flag would need to be clear when Area Segment SID is present. > The A flag seems not applicable to Area Segment SID > And your encoding violates the current definition of Binding TLVs. > Specifically, https://www.rfc-editor.org/rfc/rfc8667.html#section-2.4.4 > <https://www.rfc-editor.org/rfc/rfc8667.html#section-2.4.4> states: > > “The Prefix-SID sub-TLV is defined in Section 2.1 > <https://www.rfc-editor.org/rfc/rfc8667.html#PREFIXSIDSUBTLV> and contains > the SID/Index/Label value associated with the prefix and range. > The Prefix-SID sub-TLV MUST be present in the SID/Label Binding TLV when the > M-Flag is clear. > The Prefix-SID sub-TLV MUST NOT be present when the M-Flag is set.” > > While some changes to this definition are likely required to support Area > Segment SID no matter what, it is hard for me to see a good way to do this > w/o adding a new flag. I’m open to suggestions here. We are abusing the definition of the Binding TLV. 2.4 says: "The SID/Label Binding TLV may be used to advertise prefixes to SID/Label mappings.” That’s not what we’re doing, so it’s not too surprising that there’s some conflicts. Tony
_______________________________________________ Lsr mailing list Lsr@ietf.org https://www.ietf.org/mailman/listinfo/lsr
