Hai,
I am using imx23 evk board and L2.6.31_10.05.02_ER_source(Ltib)
BSP to build images,
doing fine with images but not able to get eth0 after i booted
from sdcad, while configuring Ltib i selected
boot stream option and i set the ip-address
started networking, enabled Interface 0 and set the ip,
broadcast netmask and gateway address.
But im not able to get eth0, while booting it showing
"IP-Config: No network devices available"
with this mail i attached the boot information, Please do needed.
--
*Regards
Jayanthkumar
9844598977
*
boot-info
Description: Binary data
_______________________________________________ LTIB home page: http://ltib.org Ltib mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/ltib
