Zivjo!
On Fri, 28 Jul 2000, [EMAIL PROTECTED] wrote:
> Na vaše vprašanje sicer ne vem odgovora, ker mi ni jasno, kako lahko
> operacijski sistem linux inštalirate na Windows particijo. V
Obstaja dodatek DOS datotecnemu sistemu, ki se imenuje
UMSDOS (vkljuci se ga v Linux kernelu pod MSDOS datotecnim
sistemom). Prilagam pozetek iz pomoci pri nastavitvi jedra:
Say Y here if you want to run Linux from within an existing DOS
partition of your hard drive. The advantage of this is that you can
get away without repartitioning your hard drive (which often implies
backing everything up and restoring afterwards) and hence you're
able to quickly try out Linux or show it to your friends; the
disadvantage is that Linux becomes susceptible to DOS viruses and
that UMSDOS is somewhat slower than ext2fs. Another use of UMSDOS
is to write files with long unix filenames to MSDOS floppies; it
also allows Unix-style softlinks and owner/permissions of files on
MSDOS floppies. You will need a program called umssync in order to
make use of umsdos; read Documentation/filesystems/umsdos.txt.
This option enlarges your kernel by about 25 kB and it only works if
you said Y to both "fat fs support" and "msdos fs support" above. If
you want to compile this as a module ( = code which can be inserted
in and removed from the running kernel whenever you want), say M
here and read Documentation/modules.txt. The module will be called
umsdos.o. Note that the filesystem of your root partition (the one
containing the directory /) cannot be a module, so saying M could be
dangerous. If unsure, say N.
Toliko o tem, jaz to odsvetujem ker krozijo govorice, da je UMSDOS
na smrt pocasen.
> dodala 6 G disk s 1024 cilindri). Ali ima kdo kakšno idejo,
> kako inštalirati dual boot na tak 30 G disk s preveč cilindri?
Tudi jaz imam boot particijo nad 1024 cilindrom:
Moj lilo.conf zgleda takole (pozornost naj zbudi
vrstica lba32):
boot=/dev/hda
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
default=linux
lba32
image=/boot/bzImage
label=linux
read-only
root=/dev/hda4
image=/boot/bzImage-2.2.15
label=old
read-only
root=/dev/hda4
image=/boot/bzImage-2.2.14-rtl2.2
label=rtlinux
read-only
root=/dev/hda4
other=/dev/hda1
label=dos
-------------------------------
LILO version 21.4-2
Priporocam, da se opravi namestitev (custom seveda)
v eno samo particijo in se ko se pojavi korak sredi namestitve
se naj naredi rescue disketa.
Lilo se bo pritozil nad 1024 cilindrom vendar zanemaris opozorila
in nadaljujes. Bootas z disketo in popravis v /etc/lilo.conf, da
vsebuje vrstico "lba32".
Nato pozenes lilo, ce LILO se se vedno pritozi mi pisi in bom
poslal novi LILO.
--
best regards,
Rok Papez.
