Ce z lba34 ne bo delalo je pa se tale fora:
boot = /dev/hda1 <- LI
boot = /dev/hda <- LILO:
s tem sem mu jest tezave.
On Tue, 17 Apr 2001, Borut Kurnik wrote:
> Lep pozdrav!
>
> /usr/share/doc/lilo-21.4.4/README ->
>
> -------------------------------------------------------------------------
>
> (<nothing>) No part of LILO has been loaded. LILO either isn't installed
>
> or the partition on which its boot sector is located isn't active.
>
>
>
> L <error> ... The first stage boot loader has been loaded and started,
>
> but it can't load the second stage boot loader. The two-digit error
>
> codes indicate the type of problem. (See also section "Disk error
>
> codes".) This condition usually indicates a media failure or a geometry
>
> mismatch (e.g. bad disk parameters, see section "Disk geometry").
>
>
>
> LI The first stage boot loader was able to load the second stage boot
>
> loader, but has failed to execute it. This can either be caused by a
>
> geometry mismatch or by moving /boot/boot.b without running the map
>
> installer.
>
>
>
> LIL The second stage boot loader has been started, but it can't load
>
> the descriptor table from the map file. This is typically caused by a
>
> media failure or by a geometry mismatch.
>
>
>
> LIL? The second stage boot loader has been loaded at an incorrect
>
> address. This is typically caused by a subtle geometry mismatch or by
>
> moving /boot/boot.b without running the map installer.
>
>
>
> LIL- The descriptor table is corrupt. This can either be caused by a
>
> geometry mismatch or by moving /boot/map without running the map
>
> installer.
>
> LILO All parts of LILO have been successfully loaded.
>
> ----------------------------------------------------------------------------
> ----------------------------------------------------------------------
>
> Torej geometrija diska ali boot.b...
>
>
>
> Borut
>
>
>
> -----Original Message-----
> From: |Birkoff| [mailto:[EMAIL PROTECTED]]
> Sent: Monday, April 16, 2001 11:53 AM
> To: [EMAIL PROTECTED]
> Subject: [ LUGOS ] LILO boot
>
>
> hi
>
> imam problem z LILO bootom in sicer ko naložim linux (RH 6.2) in se mašina
> ponovno zažene mi napiše samo "LI" namesto LILO:. Kaj bi lahko bilo narobe?
> imam pa 30GB IBM trdi disk - 4 dos particije in 2 linux (swap in native)
>
> lp, damjan
>
>
