On Sat, 30 Jun 2001, Ricardo Brisighelli wrote:
> Hola a todos, tengo una placa 3com de red que tiene conector AUI y RJ45,
> cuando cargo el modulo por defecto me toma el conector AUI, que par�metro u
> opciones le debo pasar para que me tome el RJ45.
>
> Yo prob� poniendo en el modules.conf lo siguiente
>
> options 3c509 xcvr=n irq=11
>
> donde n lo varie de 0 a 4 y no paso nada!
antes de probarla usando el modules.conf te recomiendo que lo hagas a
mano utilizando el modprobe/insmod
--- CUT ---
An example of loading the vortex module is
insmod 3c59x.o debug=1 options=0,,4 full_duplex=0,0,1
This sets the debug message level to minimal messages, sets the first
card to the 10baseT transceiver, the second to the EEPROM-set
transceiver, and the third card, a 3c595, to operate in full-duplex
mode using its 100baseTx transceiver. (Note: card ordering is set by
the PCI BIOS.) Possible media type settings
index media
0 Auto-select (default to the 10baseT link)
1 AUI
2 undefined (special case: 10baseT from the LILO prompt)
3 10base2 (BNC)
4 100baseTx Symbol mode, valid for 3c595 only.
5 100baseFx Symbol mode, valid for 3c595 only.
6 MII (the correct transceiver type on the 3c905A)
9 Cyclone External MII, for the 3c905B w/ 100baseFx or 100baseT4
0x200 Add to above values to force full-duplex.
Note that the preferred method of using full duplex is to allow
auto-negotiation to take place. Forcing full duplex is almost always
an operational error. If you must force full duplex when communicating
with older equipment, use the full_duplex module parameter in
preference to the 0x200 options flag. The 0x200 flag should only be
used with built-in drivers.
--- CUT ---
Para la version entera del documeto podes ir a
http://www.scyld.com/network/
-Jx
--
Jose Luis Diaz
Tec. en Infraestructura
Soluciones Punto Com S.A.
http://www.spcom.com.ar
