I just looked at the general linux driver for the 1020. I am going to add a quick walkthrough with a example of the bna driver. There is also a way to build a dkms rpm but I will not go into that today. The directions can be modified for any driver you need to build.
The first step should be enough if you are going to install the driver over and over for every kernel that you install. If you want the module to be auto built for every kernel installed, you can do the following. This procedure is a bit more complex than usual since the brocade source is a bit non standard. Some of these steps are not needed for other driver source that have a standard /usr/src/driver-x.x.x layout. 1. Install dkms gcc make kernel-devel install bna_driver_linux-3.0.0.0-0.noarch.rpm 2. copy the /usr/src/bna dir to /usr/src/bna-3.0.0.0-0 3. create a /usr/src/bna-3.0.0.0-0/dkms.conf file with at least the following: ##### PACKAGE_NAME=bna PACKAGE_VERSION=3.0.0.0-0 BUILT_MODULE_NAME[0]=bna DEST_MODULE_LOCATION[0]=/kernel/drivers/net/bna AUTOINSTALL=YES 4. edit the /usr/src/bna-3.0.0.0-0/Makefile and change the line: #### BNA_SRC := /usr/src/bna to BNA_SRC := /usr/src/bna-3.0.0.0-0 5. then add the module to the dkms build system ##### dkms add -m bna -v 3.0.0.0-0 dkms build -m bna -v 3.0.0.0-0 dkms install -m bna -v 3.0.0.0-0 6. If you need to stop using dkms ##### dkms uninstall dkms remove This will get the module to auto-build with each booted kernel. Thanks Sebastian On Nov 22, 2011, at 11:35 AM, John Richards wrote: > Lustre fans, > > I'm hoping I'm missing something obvious. I have a Brocade 1020 10G card > which works well with an unpatched kernel (currently running RHEL5.5, > 2.6.18-194.3.1). However, I'd like to use that card in an OSS, which means a > patched kernel. > > Has anyone either found a way to use the distributed kernel modules from > Brocade (bna) with a lustre patched kernel > (2.6.18-238.12.1.el5_lustre.g266a955 for example), or compiled Lustre from > source with support for this card (which probably involves compiling a new > network stack using code from Brocade that I can't find). > > Thanks for suggestions, > > John Richards > john.richa...@icecube.wisc.edu > _______________________________________________ > Lustre-discuss mailing list > Lustre-discuss@lists.lustre.org > http://lists.lustre.org/mailman/listinfo/lustre-discuss _______________________________________________ Lustre-discuss mailing list Lustre-discuss@lists.lustre.org http://lists.lustre.org/mailman/listinfo/lustre-discuss
