Hi folks,
This one for happy new year. I merged pending patches and
extended/cleaned up some part of the code.
I would like to thanks contributors !
Following ChangeLog for this release:
2014-01-02 Alexandre Cassen <acas...@linux-vs.org>
* keepalived-1.2.10 released.
* Jonas Johansson removed unused option character in getopt
optstring.
* vrrp: disable TTL sanity check for unicast use-case.
In order to protect against any packet injection, VRRP
provides sanity check over IP header TTL. This TTL MUST be
equal to 255 and means both sender and receiver are attached
on the same ethernet segment. Now with unicast extension this
protection MUST be disabled since VRRP adverts will mostly
traverse different network segments.
!!! WARNING !!! When using VRRP in unicast use-case in order
to protect against any packet injection the best practice is
to use IPSEC-AH auth method otherwise you are exposed to
potential attackers !
* Christian Albrecht fixed minor typo in man page
* Pim van den Berg work on libipvs-2.6 to sync with libipvs from
ipvsadm 1.27
* Pim van den Berg work add support to libnk >= 3. This address
following considerations :
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=688164
http://article.gmane.org/gmane.linux.keepalived.devel/3522
* Pim van den Berg extended libipvs adding nlerr2syserr function
to translate libnl 3 errors to sys errors. In libnl 3 the
return codes have changed. nlerr2syserr translates the libnl
3 errors to sys errors.
* ipvs: if libnl-3 is installed then check for libnl-gen-3. It
is mandatory to use generic netlink facilities in new
libipvs. This test is just here to ensure every needed libs
are installed !
* Frank Baalbergen (I suppose github frankbb is you ?) fix
http checker. literal ipv6 addresses should be enclosed by
brackets.
* vrrp: Frank Baalbergen add check on IFA_F_NODAD support.
* vrrp: fix unicast handling address selection. SjonHortensius
reported issue while testing unicast_peer. It wouldn't work
without adding the native_ipv6 flag. Removed this dependency !
since it not correlated with VRRP protocol version used.
* vrrp: extend ip parser to support default and default6.
When you are using virtual_routes you may want to use default
or default6 while configuring routes. Extended parser
accordingly !
* vrrp: take care of label while comparing IP addresses.
Label was not taken into account while comparing 2 IP
addresses, this can lead to a non deletion while stopping
daemon and some configuration changes have been done while
deamon running. This issue was reported by Stepan Rogov.
* vrrp: fix/extend gratuitous ARP handling.
multiple people reported issues where MASTER didnt recover
properly after outage due to no gratuitous ARP sent. VRRP
is a protocol designed to be used between node plugged on
the same layer2 in order to guarantee link failure is directly
linked to a protocol FSM handling (FAULT transition). With
current virtualization env quite every think can be
virtualized from host (VM) to network (vswitch). In some
cases those virtualized env offer a virtualized layer2 on
which VRRP is plugged and sometime forwarding or routing over
this virtual path can be broken.
I extended gratuitous ARP handling in 2 ways :
1) When a MASTER receive a higher prio advert it sends a last
advert before transiting to BACKUP state. The immediate
effect at remote MASTER side is to sollicite a gratuitous
ARP broadcast.
2) Add an optional support to periodic gratuitous ARP sending
while in MASTER state. By default it is disabled but one
can activate this feature by configuring keyword
"garp_master_refresh" in seconds in vrrp_instance block
(refer to keepalived.conf.SYNOPSIS).
* Frank Baalbergen fixed genhash. genhash can throw a
segmentation fault when not providing an argument
* Frank Baalbergen extended genhash code to support IPv6
* Frank Baalbergen extended genhash code to make url default
value /, same as curl/wget
* Frank Baalbergen extended genhash code to only use default
url when url is empty
* vrrp: Create configuration alias for unicast_src_ip keyword.
Add a new keyword more generic to specify VRRP packet source
IP address. This new keyword is "unicast_src_ip" and have
exactly the same scope as "mcast_src_ip".
* vrrp: unicast_peer addresses and VRRP instance MUST be of
the same family. VRRP low-level framework create socket
pool based on VRRP instance family. If you are using
unicast_peer, it is mandatory to use addresses of same family
as VRRP instance. You cant mix IPv4 and IPv6 addresses inside
same unicast_peer block. If you need to make it that way, you
MUST create a VRRP instance per family, eg: one with
native_ipv6 for v6 unicast_peer and another for v4
unicast_peer.
* vrrp: extended unicast code to support IPv6 unicast_src_ip.
Add support to unicast IPv6 address for
{unicast,mcast}_src_ip keyword. vrrp instance saddr is now a
sockaddr_storage and src IPv6 address is set using cmsg
ancillary data pktinfo. TSource IP address selection is now
generic and can be IPv4 or IPv6.
* vrrp: fix vrrp socket sync while leaving FAULT state.
Well, this is a very, VERY old bug here. while leaving FAULT
state VRRP framework refresh instance socket fd_in & fd_out
and synchronize all VRRP instance bound to the same socket.
The patch refresh socket, it also refresh fd hashing ! which
better for later fault handling :)
* vrrp: Frank Baalbergen fix log-facility handling. log-facility
should be a required_argument
* vrrp: Support xmit VRRP packets from base VMAC interface.
Here is a merge of patch from Oliver Smith. Thanks for your
job and idea in here Oliver. Comments from Olivier :
This provides a new option to use in conjunction with the VMAC
functionality which will result in VRRP advertisements being
sent and received over the underlying interface (and therefore
having the source MAC of that interface rather than the VMAC
device).
With this new functionality enabled, VRRP messages will not
affect the switch MAC address table since the non-unique VMAC
address is now used only for sending a gratuitous ARP, thereby
ensuring that in conditions of VRRP message loss, a probing
partner will not inadvertently take over traffic.
This also resolves issues where VRRP messages are not
successfully being seen on the VMAC interface as with the
new option, the underlying interface is also used to listen
out for VRRP messages.
* getopt: Make some arguments required
* vrrp: Frank Baalbergen add default case in getopt_long.
when starting keepalived with an option without an argument
that requires an argument keepalived should not be started.
* vrrp: VMAC code cleanup and extensions.
Remastered VMAC code. Interface base_ifindex is set by default
to interface ifindex during netlink probe. VMAC interface
base_ifindex is now set during VMAC allocation uppon success
interface creation. Detect if virtual_router_id is declared
after use_mvac keyword is invoked. Add some more log while
setting up and removing VMAC interface.
* vrrp: IPv4 & IPv6 multicast group tweaking.
Meno Abels extended vrrp framework to support customized
multicast addresses. The address could be set for ipv4 and
ipv6 in the global_defs config section using the keywords
vrrp_mcast_group4 and vrrp_mcast_group6.
There are some stupid switches which does a special processing
to 224.0.0.0/8 multicast packets which causes packets drop
from queue overflows in environments which creates 100 and
more multicast control plane packets a second.
Enjoy,
Alexandre
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@LinuxVirtualServer.org
Send requests to lvs-users-requ...@linuxvirtualserver.org
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
