On 03/23/2016 03:15 PM, efersept wrote: > If I wanted to attach containers to a simple bridged interface and > give them IPs on my network would it be as simple as creating the > following entry in the container's config after the bridge was setup > on the host?
That is how we are doing it. We created a profile for each bridge on the host and assigned them to the container, mapping a different "eth" in the container itself. It works well but we are also open for suggestions on alternative approaches. Regards CONFIDENTIALITY NOTICE: This email message (and any attachment) is intended only for the individual or entity to which it is addressed. The information in this email is confidential and may contain information that is legally privileged or exempt from disclosure under applicable law. If you are not the intended recipient, you are strictly prohibited from reading, using, publishing or disseminating such information and upon receipt, must permanently delete the original and destroy any copies. We take steps to protect against viruses and other defects but advise you to carry out your own checks and precautions as Kambi does not accept any liability for any which remain. Thank you for your co-operation. _______________________________________________ lxc-users mailing list lxc-users@lists.linuxcontainers.org http://lists.linuxcontainers.org/listinfo/lxc-users