Hi Thomas, Can you list the steps you went through to get it working? I'm in the same boat.
thanks. On Fri, May 19, 2017 at 8:31 PM, Thomas Ward <tew...@ubuntu.com> wrote: > Thanks to some off-list replies and some help from other online > resources, I've been able to switch this to a bridged method, with the > host interfaces set to 'manual', an inet0 bridge created that is static > IP'd for the host system to have its primary IP, and can have manual IP > assignments to containers on that bridged network for the other > non-primary IPs. I've also kept an `lxdbr0` device from the older > lxd-bridge setup that I still had for NAT'd containers, since I have > more containers than public IPs, and many of the containers don't need > to be on public IPs. > > Thank you to the people who replied to me off-list, but also the people > in general who help people new to LXC/LXD networking get started working > through issues they've run into! > > > Thomas > > > On 05/19/2017 10:01 PM, Thomas Ward wrote: >> Hello. >> >> I've got a VDS from RamNode - which is essentially a KVM VPS with >> dedicated CPUs, and larger RAM capacity. This VDS has three IPs. I'm >> going to obfuscate them here, but essentially the host box is configured >> like this: >> >> >> # The primary network interface >> auto ens3 >> iface ens3 inet static >> address 1.2.3.107 >> netmask 255.255.255.0 >> gateway 1.2.3.1 >> dns-nameserver 8.8.8.8 8.8.4.4 >> >> auto ens3:1 >> iface ens3:2 inet static >> address 1.2.4.17 >> netmask 255.255.255.0 >> gateway 1.2.4.1 >> dns-nameserver 8.8.8.8 8.8.4.4 >> >> auto ens3:2 >> iface ens3:2 inet static >> address 1.2.4.34 >> netmask 255.255.255.0 >> gateway 1.2.4.1 >> dns-nameserver 8.8.8.8 8.8.4.4 >> >> >> Now, I've got a container I'd like to route the 1.2.4.17 to a specific >> container once I've created it, but ens3 is the only actual physical NIC >> on the system, and I don't have the ability to add any more physical NICs. >> >> How would I go about routing 1.2.4.17 to the 'new' container I'm going >> to create? >> >> Note that by default, new containers are attached to an 'lxdbr0' which >> NATs container traffic, this new container would have to reside outside >> that obviously, but I'm not fluent in LXC/LXD networking so a guide >> and/or how-tos for this would be wonderful to have. >> >> >> ------ >> >> Thomas >> > > _______________________________________________ > lxc-users mailing list > lxc-users@lists.linuxcontainers.org > http://lists.linuxcontainers.org/listinfo/lxc-users _______________________________________________ lxc-users mailing list lxc-users@lists.linuxcontainers.org http://lists.linuxcontainers.org/listinfo/lxc-users