On Mon, Jun 04, 2007 at 10:45:40PM +0200, Jean-Marc Lasgouttes wrote: > >>>>> "Herbert" == Herbert Voss <[EMAIL PROTECTED]> writes: > > Herbert> these are _all_ config files and not printer files. > > Herbert> dvips -P<config> > > Herbert> eg dvips -Pcmz <file> > > In the old days, it was not about brand new fonts, but rather metafont > modes. Typical case, besides the known problem of DPI setting: > write-white and write-black printers can produce fonts that are too > thin/thick. This is well documented in the modes.mf file.
I also question the assertion that the -P option is not for printer settings. This is an excerpt from the dvips man page: -P printername Sets up the output for the appropriate printer. This is implemented by reading in config.printername , which can then set the output pipe (as in, !lpr -Pprintername as well as the font paths and any other config.ps defaults for that printer only. Note that config.ps is read before config.printername In addition, another file called ~/.dvipsrc is searched for immediately after config.ps; this file is intended for user defaults. If no -P command is given, the environment variable PRINTER is checked. If that variable exists, and a corresponding configuration file exists, that configuration file is read in. > I am not sure however that this is still relevant with 600+ dpi > printers. And of course, metafont is getting less and less used. Not all TeX fonts are available in vector format, so I would say that this is still relevant if you have two or more printers with different resolutions. -- Enrico