Teeny can also be injected from mComm. It's quite a bit smaller too so it loads faster. I'm not sure why that error would be coming up with TS-DOS. Did you use the command "RUN COM:98N1E" from Basic? The dos injector uses xon/xoff so the flow control lines don't matter when loading.
On Tue, Jan 22, 2019, at 7:23 PM, Greg Swallow wrote: > From what I can tell the spacing et al of the Rex is the same as the > SR. The PCB of the Rex is thinner material than the SR, but the top > surface of both is level/even when the two are set next to each other. > I have made some adjusting attempts with near same result. Even > installed the Rex in one of my other MT and had the same issue there.> > I was trying to load TS-DOS injected via mComm 2.5, but that is giving > me an OD, Out of Data, error in line 5. It's my hope that the rf149.co > might have enough "diagnosis" that it can tell if the Rex is > in/programmed/whatever to further figure out what is wrong. Sill > looking for a way to load TS-DOS, anyone have a suggestion?> > God Bless, > > Greg > > ----- Original Message ----- > From: "John R. Hogerhuis" <jho...@pobox.com> > To: m...@bitchin100.com > Sent: Tuesday, January 22, 2019 7:10:41 PM > Subject: Re: [M100] Unable to Load TEENY to MT > > In my experience it's an issue of good contact pressure between > all pins> and the socket, and the proper spacer between rex and the > socket bottom.> > -- John.
