I like what you did to try to reduce the stress risers as much as possible for the hooks within the constraints.
bkw On Sun, Jul 5, 2020, 4:15 PM Steve Glenner <steveglen...@hotmail.com> wrote: > Here is the improved 3D printable M200 battery cover: > https://www.thingiverse.com/thing:4508352 > > I have made the side tabs a little more robust with a larger radius > fillet, increased the clearance of the short edge tabs, reduced the width > and length vary slightly for easier fit, and added some rib cutouts to make > a finger grip area for opening the cover. The new model came off the > printer and went right into my M200 without any post processing other than > removing the small amount of support material under the hooks and tabs. > > I have also added a second model which is a stabilizer part which will > protect all the hooks and tabs if the cover needs to be mailed. > If you need a cover and don't have access to a 3D printer contact me and I > can send one if you cover the shipping and material cost. > >