Dear community,

today I would like to share my solution for an extension of the ROM socket on 
NEC PC8300.
My idea was to avoid soldering on the replacement ROMs and also the PCB. 
Digging in my
electronics garbage box I found the items for this mod. So I took the following 
for this
 
    1 IC-socket 0,6" wide
    6 legs from a broken IC
    a piece of a silverplated bar 1mm wide, a wire would do the job too
    a piece of double-side tape
 
HowTo build: (see attachment)
    1. cut a 2-pin wide piece from the IC-socket and put the double-side tape 
on the back of it
    2. build the pin connectors, just a small soldering work. I used a 32-pin 
IC-socket as jig for this
    3. remove protection from double-side tape and place socket extension on PCB
    4. push the pin connectors into the right place and bend them to the inner 
side of the socket

That´s it

Thanks to Gary Weber for details to NEC PC8300 ROM replacement on his WebSite

RegardsGeorg
 
Confidentiality Notice:
This message is confidential. The information contained in this message is 
intended only for the personal
and confidential use of the recipient(s) named above. If you are not the 
intended recipient, please do not
read, copy, or use it and do not disclose it to others. Please inform us 
immediately of the delivery error
and return the original message to us via e-mail.

Attachment: NEC-PC8300 MainROM socket extension.pdf
Description: Adobe PDF document

Reply via email to