Sorry, we cannot guess what your hal and ini files contain.
Homing can be difficult and unintuitive sometimes, but without seeing
how yours is set up, no-one can assist.
regards
On 07/01/2018 01:42, gary wrote:
I just connected a BBB and Cramps board to my delta printer, but i
have been having homing problem
I have optic switches installed if i go into the hal configuration
when machinekit it booted, and then to the show window with xmax ymax
and zmax displayed then when axis's are off the switches there red,
and when i trigger the switches they turn yellow
So i assume the switches are working and being read by the software.
But when i do home all the motors they move up to the switches in the
correct direction but never stop just keeps running into the optic
end stops and i have to power down..
any suggestions?
Thanks gary
--
website: http://www.machinekit.io blog: http://blog.machinekit.io
github: https://github.com/machinekit
---
You received this message because you are subscribed to the Google
Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to machinekit+unsubscr...@googlegroups.com
<mailto:machinekit+unsubscr...@googlegroups.com>.
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to machinekit+unsubscr...@googlegroups.com.
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
