2012/12/27 Thomas Backlund <[email protected]>: > Wolfgang Bornath skrev 27.12.2012 16:49: > >> 2012/12/27 Thomas Backlund <[email protected]>: >>> >>> Wolfgang Bornath skrev 27.12.2012 16:29: >>> >>>> 2012/12/27 Thomas Backlund <[email protected]>: >>>>> >>>>> >>>>> Wolfgang Bornath skrev 27.12.2012 16:04: >>>>>> >>>>>> >>>>>> >>>>>> 2012/12/27 Thomas Backlund <[email protected]>: >>>>> >>>>> >>>>> >>>>> >>>>>>> can you provide either "lspcidrake -v" or "lspci -vnn" for that >>>>>>> device >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> # lspcidrake -v |grep Broadcom >>>>>> wl : Broadcom Corporation | BCN4312 802.11b/g LP-PHY [NETWORK_OTHER] >>>>>> (vendor:14e4 device:4315 subv:14e4 subd:04b5) (rev 1) >>>>>> >>>>>> That's it >>>>>> >>>>> >>>>> Thanks. that shows the subvendor/device ids. >>>>> The 4312 ones are problematic iirc... >>>>> >>>>> Now for some tests... >>>> >>>> >>>> >>>> In which mode do you want me to do that ? >>>> - live mode >>> >>> >>> >>> This wont work as you need to reboot to make sure the hw is in "good >>> state" , wich will make the "uninstall part" useless. >> >> >> Ok, that was clear. >> >>> >>>> - installed without net access (through additional cable) >>>> - installed with net access (through additional cable) ? >>> >>> you dont need cable access for the first part (1-4) but need >>> cable access (or beta1 install dvd) for second part (5-8) >>> >>> after configuration step you obviously need to disconnect the >>> cable to verify that it works with wireless. >>> >>> And you dont need to do a new install to test this, >>> a current installed/updated cauldron system should be enough. >> >> >> Ah, I need to do a new because I only have one system with this device >> :( So I just start from fresh, >> - first with non-free disabled and reboot, >> - then non-free enabled with reboot >> > > Hm, is that system running mga2 ?
No, it is running no system at all save for the one I'm going to install- It's a small harddisk holding just one. Don't bother, I'd have to re-install anyway. -- wobo
