Am 22.09.2011 23:01, schrieb Gary Montalbine:
At the end of September I mentioned that gwenview print ass't did not print
the photos with the proper color. I have included the gimp photo. This was
used in both ML and Mageia. The ML printed image and the Mageia printed image
are also included. I used print ass't in both. The mageia image shows poor
color. There is too much red.
I had to reinstall ML2010.2 to print good quality photos via gwenview and
print ass't..
I just did a retest since hplip was updated. I did a minimal install on a
flash drive and then an update of all installed software. Around 500 updates.
I then reprinted the gimppic using print ass't in Gwenview and gutenberg
print in gimp. They both produced the same unsatisfactory photos as before
and shown as mmageia.jpg.
It appears I may be the only one with this problem. I wonder if it might be
the hplip drivers. I am using a HP Photosmart Plus 209a-m. I think I remember
seeing 209a-c listed in Mageia.
I am forced to remain with ML2010.2 because of the printing issue.
Thanks, Gary
Already asked you that in private, IIRC, but have you tried with other programs?
