Hi
Finally I've installed Mageia 2 on my home machine.
There are a few problems.
There it goes...
Hardware:
MB Asus P6T Deluxe V2
Intel i7 950 CPU
12 GB of Corsair RAM
nVidia GeForce 9800 GTX
4 HDs jbod
1 RAID 0 controlled by RAID bus controller: Silicon Image, Inc. Device 0242
1 scenario
I've tried to install with the full hardware configuration.
No go.
The installer made mistakes with the RAID 0. Both disks was listed at
the partitioning step (not counting the /dev/mapper/... entry). I can't
see why the individual disks was listed, since the array was recognized.
Worst of all, the installer gives a message that can't format a swap
partition at one of the RAID disks. It shouldn't. The RAID is windows
and DON'T have a swap partition at all.
2 scenario
Removed the RAID array and tried again.
I was able to install Mageia 2 but not able to boot correctly after the
install. Systemd messages of error and I could not deal with them.
Since the fourth disk is a openSUSE 12.1 disk, I've tried to remove and
install again without the disk.
3 scenario
Installer did what was expected. No errors, boot ok, subsequent updates
fine.
Then I've reinstalled the Suse disk. No problems.
Then I've reinstalled the RAID array.
I was able to manually mount the Windows partition, but diskdrake is
showing the individual disks again. The second disk of the array is
completely crazy, showing 3 partitions (2 linux native and 1 swap).
Since the array is working fine with windows, it CAN'T be right.
If you wish, I can send lspci, lshw or whatever you find interesting.
Thanks
Luiz Alberto Saba
