Hi,
I've set up my Exim4 and Mailman configuration largely as shown on
list.org at http://list.org/mailman-install
However, when I send a message to the list, I get the following in
exim's mainlog:
[EMAIL PROTECTED] R=mailman_router T=mailman_transport:
Child process of mailman_transport transport returned 2 from command:
/usr/local/mailman/mail/mailman
I couldn't find anything in the docs about what command line options (if
any) the mailman executable might take, so I'm not sure how to
troubleshoot. I don't know if there was a problem building the
executable or if it is a configuration problem.
I said I configured it *largely* as the docs say. There were a couple
of differences. The docs showed reciever verification like this:
accept domains = +local_domains
endpass
message = unknown user
verify
but my config file did not have the "message" line. I didn't figure
this would make any real difference.
I tried to put the SMTP Callback stanza (secion 6.2.10 of the docs) into
my exim.conf, but this caused exim to barf. Since I didn't understand
what it was doing, and hence how to fix it, I commented it out. I got
the impression it was optional. Was I wrong?
Does this sound like a configuration problem? If so, where should I look?
Thanks!
Steve
------------------------------------------------------
Mailman-Users mailing list
Mailman-Users@python.org
http://mail.python.org/mailman/listinfo/mailman-users
Mailman FAQ: http://www.python.org/cgi-bin/faqw-mm.py
Searchable Archives: http://www.mail-archive.com/mailman-users%40python.org/
Unsubscribe:
http://mail.python.org/mailman/options/mailman-users/archive%40jab.org
Security Policy:
http://www.python.org/cgi-bin/faqw-mm.py?req=show&file=faq01.027.htp
