yOU HAVE TO SET THE COORDINAT SYSTEM WITH A MAPbasic command so MapInfo will
update you columns using UTM instead of Lat/Long.
In the MapBasic window, type: (where MyTableName is an open table with UTM
coordsys.)
Set CoordSys Table MyTableName
//Hälsningar / Regards
Gustaf Svedjemo
~~~~~~~~~~~~~~~~~~~~~
Högskolan på Gotland / Gotland University College
Cramérgatan 3
S-621 57 Visby
Sweden
E-post / Email: [EMAIL PROTECTED]
Tel / Phone: +46 (0)498 29 98 86
Fax: +46 (0)498 29 98 32
WWW: http://www.hgo.se
~~~~~~~~~~~~~~~~~~~~
-----Ursprungligt meddelande-----
Från: Peter Taylor [SMTP:[EMAIL PROTECTED]]
Skickat: Wednesday, March 21, 2001 12:07 AM
Till: [EMAIL PROTECTED]
Ämne: MI-L convert lat/long to UTM
I extracted the centroids from some polygons in a table.
1) added two fields (float) to a table.
2) update columns using centroidx(object) centroidx(object)
3) the result is in Lat/Long -122.513, 49.0157
My problem is I use UTM zone 10 (NAD 83) projection. 535,581,28,
5,429,316.75
Is there a way to convert lat/long to UTM?
Thanks,
Peter
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.