MATPOWER assumes the network is balanced so only a positive sequence power flow calculation is performed for transmission and distribution. If you’d like to do an unbalanced distribution power flow calculation then you’ll need to use other tools like OpenDSS or GridLab-D.
Shri From: Akash Tyagi <akashtyagi0...@gmail.com<mailto:akashtyagi0...@gmail.com>> Reply-To: MATPOWER discussion forum <matpowe...@list.cornell.edu<mailto:matpowe...@list.cornell.edu>> Date: Sunday, April 2, 2017 at 2:15 AM To: MATPOWER discussion forum <matpowe...@list.cornell.edu<mailto:matpowe...@list.cornell.edu>> Subject: Re: False Data Detection in State Estimation Hello everyone, I got familiar with the distribution power flow and power flow in MATPOWER, but i want to know about the phases.? The power flow we are doing in for single phase?? And if it is for single phase than i want to know, how power flow for three phase is solved using MATPOWER? Thanks in advance. On Thu, Mar 23, 2017 at 11:00 PM, Ray Zimmerman <r...@cornell.edu<mailto:r...@cornell.edu>> wrote: First, please send your MATPOWER questions to the MATPOWER-L list at MATPOWER-L@cornell.edu<mailto:MATPOWER-L@cornell.edu> (not to the list owner). The state estimation code in MATPOWER is contributed code that is not a supported part of the main MATPOWER functionality. So, all I can do is point you to the included documentation and suggest you follow up with the original author Rui Bo if you have questions. I would start by checking out the contents of the extras/se directory in MATPOWER. In particular, you’ll want to have a look at the se_intro.pdf document there that describes the code. Ray On Mar 23, 2017, at 10:20 AM, Saeed Ahmed <saeed.ahme...@gmail.com<mailto:saeed.ahme...@gmail.com>> wrote: Respected All, I am doing research on the topic of "Detection of false data injection on Power State Estimation". I have installed MATPOWER 6.0 and need guidance to start work. After reading some literature I have build up an understanding as follows: 1) State estimation in DC/Linear power network is to estimate the phase angles by observing the measurements 2) Voltage magnitudes are assumed 1pu Now starting with the simplest case of 9 buses, how can I initiate the state estimation using MATPOWER? Regards Saeed Ahmed