Since updating my boot disks to WinPE 10, I am finding that the initial call to WPEInit -winpe is taking a very long time. What used to take 20-30 seconds is now taking 2 - 3 minutes. I don't know too much about the changes between WinPE 5 (8.1) and WinPE 10 (CB1511) I also haven't tried to move to 1607 yet. I am using 1511 + the hotfix.
Are there any tricks people know of to make wpeinit -winpe go faster? Has anyone else seen a massive slowdown here after moving to WinPE 10? I am initializing WinPE on my own prior to TS because we have 802.1x network and I have to initialize and authenticate to the network in WinPE before the task engine starts. ________________________________ Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521 and is intended only for the use of the individual or entity to which it is addressed, and may contain information that is privileged, confidential, and exempt from disclosure under applicable law. If you are not the intended recipient, any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately and delete or destroy all copies of the original message and attachments thereto. Email sent to or from UI Health Care may be retained as required by law or regulation. Thank you. ________________________________
