Andrew,
Flange specs are as follows:
Holes - 9mm
Hole spacing - 73x40
Outer flange dims - 91x65
Hole in middle - 49x37.5, 12mm rads in corners
PL
PS: I'll call you about the new turbo - it's on and going. Very happy. Even
better response than the std. turbo, but with more top end. I can't test the
top end properly though because now my clutch is now slipping...
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf Of Andrew Denniss
Sent: Thursday, 7 December 2000 19:40
To: [EMAIL PROTECTED]
Subject: GarretT25 flange spacing
Hi guys anyone have the dimensions for the flange on a T25 turbo I have
only measured roughly it came up as 90x65 plate with 4x 12mm holes 75mm
spacing and 40mm spacing can some one check if thats right as its still
on car and hard to measure. I sold my old turbo to pete libig .So I cant
measure my old one. Im about 30% done on my turbo extractors.
Thanks Andrew
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
