Thanks fellas,
I will give it a go tomorrow.
Craig
>From: [EMAIL PROTECTED]
>Reply-To: [EMAIL PROTECTED]
>To: <[EMAIL PROTECTED]>
>Subject: Re: Reversing front x member
>Date: Tue, 23 Jan 2001 13:34:06 -0000
>
>Craig,
>
>I did mine the same way as Andrew. It took about 20 minutes and was no
>problem. The end result looks pretty neat.
>
>Eddie
>England
>1969 510 4door
>[EMAIL PROTECTED]
>www.ratdat.com
>
> > I just carefully grind away the weld using an angle grinder. when you
>get
>close
> > to the mark you start to see the join, then tap them out with a hamer
>turn
>them
> > around and weld them back in.
> > Andrew Smith
> >
> > Craig Harris wrote:
> >
> > > Hello ozdators,
> > >
> > > Has anyone reversed the sleeves on a 510 front x member? Just
>wandering
>what
> > > you used to cut them and keep them level when rewelding. I was going
>to
>use
> > > a hole saw and hollow tube inserted into the sleeve as a guide so that
>the
> > > cutter didnt bounce around too much.
> > >
> > > Any ideas?
> > >
> > > Craig
> > >
> > >
>_________________________________________________________________________
> > > Get Your Private, Free E-mail from MSN Hotmail at
>http://www.hotmail.com.
> > >
> >
> >
>
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
