RE: torque settings

[Terry Rudd]

Mark,   3 times around the prescribed tightening sequence:   1    40nm (30 ft/lb) 2    60nm (44 ft/lb) 3    85nm (62 ft/lb)   regards Terry     -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of mark krawczuk Sent: Thursday, 27 September 2001 12:06 PM To: [EMAIL PROTECTED] Subject: torque settings   hi, does any body know  the torque settings for a z18 cylinder head?        mark .k --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------