RE: weber tuning

[Terry Rudd]

Dave,   Two adjustment screws on either side? Do you know what car it's off? Are you sure it's a DGV (manual choke) or DGAV (auto choke)?   Usually a 32/36 has the idle mixture screw in the base at the rear below the primary venturi and either 1 or 2 idle speed adjusters (Primary & Sec) on the throttle shaft. There is a blanked off hole on most of them in the base plate on the open side i.e. 90 degrees to the throttle linkage which is for an idle cut-out solenoid but I can't see another adjustment screw on the diagrams that I have.   regards Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of David Costello Sent: Friday, 9 November 2001 12:46 PM To: [EMAIL PROTECTED] Subject: webber tuning on the 32/36 webber, there's two adjustment screws either side is one idle mixture and one is load mixture? which screw does what?     Dave --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------