|
if the weights are stuck it will not run at full rpm.
Malcolm Terry Rudd wrote: Steve,Correct on the mechanical advance. I'd say an ignition component is not doing it's job under load eg points, electronic module, coil, capacitor etc or fuel demand is not being met. Sorry about the vague general answer but that's the way it is with tracking down this sort of problem. A dyno session is the easiest way to diagnose this type of fault, unfortunately also the most expensive.regardsTerry --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ --------------------------------------------------------------------- |
- mechanical advance Greer
- Re: mechanical advance Bob
- RE: mechanical advance Terry Rudd
- HELP please maldat
- HELP please Adam Jackson
- RE: HELP please Terry Rudd
- Re: HELP please Adam Jackson
- Re: HELP please Chris Simpson
- Re: HELP please Adam Jackson
- Re: HELP please Adam Jackson
- RE: mechanical advance Terry Rudd
- RE: mechanical advance Brad Hallett
- RE: mechanical advance Terry Rudd
- RE: mechanical advance Brad Hallett
