|
ahhhhhhhhh
thanks for that, someone told me the S meant
Siamesed Blocks, and that there was some difference between the 2, I must have
been miss informed, thanks Mal
----- Original Message -----
Sent: Tuesday, September 24, 2002 4:47
PM
Subject: Re: block identification
E=EFI
S=single carb
the engines are the same
Malcolm
----- Original Message -----
Sent: Tuesday, September 24, 2002 4:43
PM
Subject: block identification
are there any markings on a Z20 block to look
for to tell whether you have a Z20E or Z20S block? is either stronger than
the other?
how far can you safely bore a Z20 block that
will be running boost?
Dave
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
