You could apply 12v across the relay coil and see if it works out of the circuit. Also measure to verify that the relay coil is getting 12v when the key is in the start position.
Does it start with the jumper in place? On Sat, Apr 16, 2011 at 1:50 PM, Robert Massmann <rmassm...@embarqmail.com>wrote: > I checked the relay out cleaned contact and found that there was a > disconnect between the relay contact and the exit pin 87 of the relay. I > fixed that with a jumper wire between the conact and the pin. I reinstalled > the relay but found that the relay is not closing, not sure why yet so I am > closing the contact with a jumper wire. I think this circuit only gets power > when the key is turned to the start position. > > Bob Massmann > > > -- > OK Don 2001 ML320 1992 300D 2.5T 1990 300D 2.5T 1997 Plymouth Grand Voyager _______________________________________ http://www.okiebenz.com For new and used parts go to www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com