Rich, i like that idea, could make wider than necessary and hose-clamp in place until the too-big pipe is slid over it.
-- Max Dillon Charleston SC '95 E300 '87 300TD Rich Thomas <richthomas79td...@constructivity.net> wrote: >cut some metal to roll into a shim. > >--R > >On 9/8/12 8:24 AM, Max Dillon wrote: >> Anyone have a recommendation for a product to fill in an exhaust pipe >> diameter mis-match? Would JB Weld be a good choice? >> >> >> >> I had to cut out my catalytic converter, and the Y-pipe junction used >to do >> this is a little to large. Muffler clamps and a couple relief cuts >will not >> clamp it down tight enough to eliminate the leaks. >> >> >> >> Very respectfully, >> /s/ >> LCDR Meade M. Dillon, USN, Retired!!! >> >> >> >> _______________________________________ >> http://www.okiebenz.com >> For new and used parts go to www.okiebenz.com >> To search list archives http://www.okiebenz.com/archive/ >> >> To Unsubscribe or change delivery options go to: >> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com >> > > >_______________________________________ >http://www.okiebenz.com >For new and used parts go to www.okiebenz.com >To search list archives http://www.okiebenz.com/archive/ > >To Unsubscribe or change delivery options go to: >http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com _______________________________________ http://www.okiebenz.com For new and used parts go to www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
