Thx Max - So... i will remove the snap ring and the nozzle will slide
out? i assume the larger o-ring is closest to the hose nozzle and the
smaller goes toward the rear of the FH?
Thanks again,
Larry
On 6/24/2014 7:30 PM, Meade Dillon wrote:
Larry,
Did this job on my '87 300TD years ago, as I recall the working parts are
quite boring. Not a whole lot to it. The interior assembly slides out, be
careful to keep out the dirt.
I also replaced both o-rings, the interior o-ring probably was fine and
didn't need to be replaced.
Max Dillon,
Charleston SC
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
All posts are the result of individual contributors and as such, those
individuals are responsible for the content of the post. The list owner has no
control over the content of the messages of each contributor.
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
All posts are the result of individual contributors and as such, those
individuals are responsible for the content of the post. The list owner has no
control over the content of the messages of each contributor.