It's 8mm on your 606 Sent from my iPhone
> On Feb 16, 2017, at 8:36 AM, Bob Rentfro via Mercedes <mercedes@okiebenz.com> > wrote: > > So what size is that big bolt that twists into the block? > > Bob R > > On Wed, Feb 15, 2017 at 10:06 PM, Craig via Mercedes <mercedes@okiebenz.com> > wrote: > >> On Wed, 15 Feb 2017 23:16:30 -0500 Max Dillon via Mercedes >> <mercedes@okiebenz.com> wrote: >> >>> On the OM603 engine, the water pump casing has ribs. The pulley wheel >>> has holes near the center that you can reach from behind. Fit the >>> biggest hex key you can find in one of these holes, the key against a >>> rib will then stop the pulley wheel from turning, so you can loosen the >>> bolt holding the clutch onto the wheel. I think this will also work on >>> your engine. >> >> That's what is done on the M104. >> >> >> Craig >> >> _______________________________________ >> http://www.okiebenz.com >> >> To search list archives http://www.okiebenz.com/archive/ >> >> To Unsubscribe or change delivery options go to: >> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com >> >> > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com