Oh forgot to say that I used small ductwork sheet
metal screws. Very sharp point and short. Worked
great.
MG
Allan Streib via Mercedes wrote:
Long-ish story, but I'm working on making a custom transisition piece
between two non-standard duct sizes. I have mocked up what I need to
make using paperboard, but for the sheet metal I'll need to connect a
few lap seams. I recall that auto panel assembly now uses some sort of
glue rather than spot welds. Is this something I can find at FLAPS or am
I better off using screws or pop-rivets? I don't have a spot welder.
And yes it needs to be sheet-metal not insulated duct board.
Allan
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
