Rusty should be able to get you set up, give him a call or send an email
tonight. On the 603, I have done it. I think your 601 probably has only
the 2 line clips. the trick is to make sure the rubber pad is behind the
line, then stick both legs of the clip in. then take a fairly big flat
screwdriver and push one side in, then the other. once in a while, you can
get them to snap in without the screwdriver, but it makes it a lot
easier. The 603 has both 2 line and 3 line clips. Actually the last order
I think I ordered 1 2 line clip and got 10. I have a whole mess of spares
now, but with 3 603s, I figure I will use them up in time.
At 03:40 PM 10/4/2006, you wrote:
After I replaced the bad injector line last night I noticed there are very
few plastic clips anywhere on the lines.
Rusty's site says I should have 5 lines total, I also have a plastic
bumper that doesn't seem to show up on Rusty's list. Anybody BTDT on a 601?
Theres a thread on the Bimby board about it but I can't recall my login
and password over there and it takes awhile for it to reset them.
-Curt
---------------------------------
All-new Yahoo! Mail - Fire up a more powerful email and get things done
faster.
_______________________________________
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
Loren Faeth
