Thanks Ned. Where did you get the timing pin tool? Rusty? I did find the pdf's for the IP r&r on the OM 606 engine. The CD is so cumbersome and one has to dig through the individual pdf's. Here they are if anyone cares: IP R&R: 07.1-8410 Pos. sensor: 07.1-8240 Timing device: 07.1-8050 Timing of IP: 07.1-8014
On 11/24/06, ned kleinhenz <[EMAIL PROTECTED]> wrote:
<< Is there a procedure for R&I of the IP anywhere (marking in the timinng)? I couln't find anything on the SML.>> Hans: I think you're looking for the IP pump R&R in the shop manual. I can probably help you off-list. I did pretty much the same procedure, last summer to replace the IP timing gear / Vac pump driver. It's not rocket science, but kind of time consuming. And you do have to mess with the cam timing and remove the chain tensioner. I recommend removing the intake manifold system and injector lines, the fan, belt, and vac pump. I'm not sure removing all that stuff is required. But from experience I can say the job goes much quicker if you take the time to do that. Be sure to order an intake manifold gasket, and an IP pump timing pin tool. It would also be a perfect opportunitiy to replace all five clear plastic lines, and o-rings around the IP, if you haven't done that already. On my '95, one of the black rubber coated fuel lines from the tank was starting to weep too. My IP pump o-ring looked OK, last summer, so I didn't replace it. But right now I'm wishing I had taken more time to get a new one from Rusty. Good luck, Ned Kleinhenz '95 E300D x2 '85 300D '80 300TD _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
-- Hans Neureiter, Houston, TX '82 300SD, '95 E300D
