Without head gasket as per manual. PEter -----Original Message----- From: Tom Hargrave [mailto:[EMAIL PROTECTED] Sent: 22 February 2007 03:18 PM To: 'Mercedes Discussion List' Subject: Re: [MBZ] Piston protrusion limits
Peter, Is the limit measured with or without the head gasket in place? Thanks, Tom Hargrave www.kegkits.com 256-656-1924 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Peter Merle Sent: Thursday, February 22, 2007 3:10 AM To: Mercedes Discussion List Subject: [MBZ] Piston protrusion limits After rebuilding my 300D I measured piston protrusion at 0.8mm which is just within spec of 0.9mm. I find it strange in that the block is just 0.1mm short of a new one which means I should actual have 0.3mm available. What is the limiting factor - prechamber collision or valve collision with pistons. Has anyone got figure for valve lift vs crank position for the non-turbo ? Peter _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com