On Thu, Aug 28, 2014 at 4:19 AM, kongling <k870818...@outlook.com> wrote: > Hi, > Thanks for your reply! > > I checked local.conf in "fsl-arm-yocto-bsp/build/conf" and > "fsl-arm-yocto-bsp/conf". There was no "DISTRO_FEATURE_remove = "x11 wayland > directfb"" in them . > After this, I added "DISTRO_FEATURE_remove = "x11 wayland directfb"" in > these two files, but it still failed with the same error.
When I change DISTRO_FEATURE in my local.conf, mainly when changing the backend GPU configuration, I prefer to use a clean build folder. In fact, I always start a new build folder for that. However, if you´re using fsl-setup-release your local.conf should be setup properly. I would suggest you start over and use the script again. Daiane > > BR, > kongling > > >> From: lauren.p...@freescale.com >> To: k870818...@outlook.com; meta-freescale@yoctoproject.org >> Subject: RE: [meta-freescale] Build error occured when build >> "fsl-image-fb" and "fsl-image-weston" >> Date: Tue, 26 Aug 2014 14:52:52 +0000 > >> >> You are using our release layer for GA. >> >> You can use daisy community which also has 3.10.17 if you want. >> >> You are doing everything right for setting up frame buffer (note for >> wayland/Weston you need a separate build) >> >> What I would check is local.conf and make sure in local.conf there is a >> DISTRO_FEATURE_remove = "x11 wayland directfb" >> >> fsl-image-fb is in the meta-fsl-bsp-release layer and bblayer.conf is what >> hooks it in (through our fsl-setup-release script you run). >> >> fsl-image-fb has a check for distro features so if the distro features do >> not match it can fail but not usually in the error you mentioned. >> >> Regards, >> Lauren Post >> > > -- > _______________________________________________ > meta-freescale mailing list > meta-freescale@yoctoproject.org > https://lists.yoctoproject.org/listinfo/meta-freescale > -- _______________________________________________ meta-freescale mailing list meta-freescale@yoctoproject.org https://lists.yoctoproject.org/listinfo/meta-freescale