Dear NXP,

I have an iMX7dsabresd board and would like to boot it from NAND using MfgTool 
V2.
I have tried to use mfgtool2-yocto-mx-sabresd-nand.vbs script provided in 
MfgTool V2, but failed.
I replaced the "sabreauto" with "sabresd" in the same script and I also rebuild 
Mfg Tools firmware (fsl-arm-yocto-bsp.git) and updated 
fsl-image-mfgtool-initramfs-imx7dsabresd.cpio.gz.u-boot in the MfgTool. But 
still fails

These are the last lines from the console output:

UTP: received command '$ mount -t debugfs debugfs /sys/kernel/debug'
UTP: executing "mount -t debugfs debugfs /sys/kernel/debug"
UTP: sending Success to kernel for command $ mount -t debugfs debugfs 
/sys/kernel/debug.
utp_poll: pass returned.
UTP: received command '$ flash_erase /dev/mtd0 0 0'
UTP: executing "flash_erase /dev/mtd0 0 0"
flash_erase: error!: /dev/mtd0
             error 2 (No such file or directory)
UTP: sending Non-success to kernel for command $ flash_erase /dev/mtd0 0 0.
utp_poll: exit with status 65280

Is mfgtool2-yocto-mx-sabresd-nand.vbs the right file to flash NAND for 
iMX7dsabresd board or I need to create my own script?
I checked the iMX Yocto Project Guide, iMX Linux User Guide, MfgTool2 
documentation, but was not able to figure out. Could you provide the steps to 
flash NAND?

Best Regards,
Carlos


________________________________
The information contained in this message may be confidential and legally 
protected under applicable law. The message is intended solely for the 
addressee(s). If you are not the intended recipient, you are hereby notified 
that any use, forwarding, dissemination, or reproduction of this message is 
strictly prohibited and may be unlawful. If you are not the intended recipient, 
please contact the sender by return e-mail and destroy all copies of the 
original message.
-- 
_______________________________________________
meta-freescale mailing list
meta-freescale@yoctoproject.org
https://lists.yoctoproject.org/listinfo/meta-freescale

Reply via email to