Ken, I did it in the editor installer and tested it! It worked for me...
Make sure you set the visibility before clonage > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Ken Ray > Sent: Wednesday, September 10, 2003 16:26 > To: [EMAIL PROTECTED] > Subject: RE: Clone stack invisibly > > > I think what doesn't work is trying to clone a substack that is > invisible whose mainstack is visible. When I do this, the cloned > substack appears visible. > > Ken Ray > Sons of Thunder Software > Email: [EMAIL PROTECTED] > Web Site: http://www.sonsothunder.com/ > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of Robert Brenstein > > Sent: Wednesday, September 10, 2003 2:25 AM > > To: [EMAIL PROTECTED] > > Subject: Re: Clone stack invisibly > > > > > > >Just make the stack not visible before cloning it. > > > > > >Tested in the Script Editor installer... For a later release! ;) > > > > > > > I can confirm that this works. However, a word of caution: when a > > stack opens invisible, it does not get all of the normally expected > > "open" messages (behavior confirmed by Scott Raney so not considered > > as a bug so far). > > > > Robert Brenstein _______________________________________________ > > metacard mailing list > > [EMAIL PROTECTED] > > http://lists.runrev.com/mailman/listinfo/metac> ard > > > > > _______________________________________________ > metacard mailing list > [EMAIL PROTECTED] > http://lists.runrev.com/mailman/listinfo/metacard > _______________________________________________ metacard mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/metacard
