I've had this happen when the lead-in and lead-out was the exact same as the tool radius. I'm sure there are other times as well, if it coded before start looking at your changes first.
On Thursday, March 09, 2000 12:16 PM, Zsiros, Pete [SMTP:[EMAIL PROTECTED]] wrote: > Hi Gang! > > I pulled up an old mill file, made some changes, but when I try to code it, > it crashes. "This application has perforemed an illegal operation, Blah blah > blah. I tried it on V9.5, AND on V11.5:same results. Has anybody else seen > this? What is the solution? > > Thanks > > Pete Zsiros > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
