i believe it's called ladder logic the devices are called PLC's (programmable logic controller) "G-code" is the user interface language we see on our monitors (assuming you aren't using a conversational type controller... a few years back Fanuc did something called FAPT)
At 10:56 AM 4/11/2000 -0400, Colin Williams wrote: >Just a general question. > >Does anybody know what operating system or language Fanuc controls use? > > >Thank You > >Colin Williams >Wabtec Corporation > > > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== > > Ernie Gemmel CNC Supervisor Apollo Microwaves Ltd. Tel (514)426-5959 Fax (514)426-3747 ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
