This is what my statement looks like. It is still calling up the feedrate. @FXD1 < #ABSI>< #FXD>< #RTNLVL>< X#XPOS>< Y#YPOS>< Z#ZDPTH R#ZCHK>< F#FEED>
Colin -----Original Message----- From: Chinh N Pham <[EMAIL PROTECTED]> To: 'Colin Williams' <[EMAIL PROTECTED]> Date: Monday, April 24, 2000 4:29 PM Subject: RE: [mfg-smartcam] canned cycle > >In the code gen. statement, put the feed rate call out in brackets <>, then >it won't output same FEED value unless it is different. ><F#FEED> > >Chinh >> -----Original Message----- >> From: [EMAIL PROTECTED] >> [mailto:[EMAIL PROTECTED]]On Behalf Of Colin Williams >> Sent: Monday, April 24, 2000 3:38 PM >> To: Smartcam Forum >> Subject: [mfg-smartcam] canned cycle >> >> >> pmill v11.0: >> >> When using canned cycles on different faces you would >> normally cancel (g80) >> then go onto the next face. Every time you call up the same >> canned cycle for >> different faces the feedrate is also called up. Is there a >> way just to call >> up the feedrate just at the first canned cycle? This way the >> operator just >> has to change the first feedrate. >> >> Thank You >> >> Colin Williams >> Wabtec Corporation Thank You Colin Williams Wabtec Corporation ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
