Matt, What I need to do is to code canned cycles when straight milling and use g1's and g0's when I'm using a right angle head (this is a machine control limitation), I'm currently writing the tmp for the right angle head and rotab part, and I can access (from the tmp file) when I need long hand and when I can use canned code.
thanks, J.G. -----Original Message----- From: Matt Doyle [mailto:[EMAIL PROTECTED]] Sent: Wednesday, May 03, 2000 12:22 PM To: 'Joe Geraci' Subject: RE: [mfg-smartcam] Canned Cycles It should be possible to something like that. I needed to alter the output on our lathe (it was using long hand) and ended up three different types of output based on which cycle the step is set on, all output as long hand but the .smf is set to use canned cycles. The pecks use a repetitive loop. What exactly do you need? Matt -----Original Message----- From: Joe Geraci [mailto:[EMAIL PROTECTED]] Sent: Wednesday, May 03, 2000 9:58 AM To: 'Smartcam' (E-mail) Subject: [mfg-smartcam] Canned Cycles Hello SCusers, Does anyone know if its possible to switch between long hand drill cycles and canned cycles based on a test with in the tmp file ?? Thanks, J.G. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
