Thanks for the ideas I'll investigate whether or not we got the macro B turned on as the reference book does show it. This Hurco mill was purchased from an auction and literally dropped off the truck on our door step. Anyways thanks again. -----Original Message----- From: Marc A. Frazer, Sr. <[EMAIL PROTECTED]> To: Michael Senack <[EMAIL PROTECTED]>; '[EMAIL PROTECTED]' <[EMAIL PROTECTED]> Date: Friday, July 07, 2000 8:06 PM Subject: Re: [mfg-smartcam] Cutter diameter for Fanuc OM Series control
> >----- Original Message ----- >From: Michael Senack <[EMAIL PROTECTED]> >To: '[EMAIL PROTECTED]' <[EMAIL PROTECTED]> >Sent: , 7 7, 00 4:59 PM >Subject: [mfg-smartcam] Cutter diameter for Fanuc OM Series control >> > Auto forwarded by a Rule >> Now we have a Hurco milling center with an OM Series Fanuc control, and >I'm >> reprogramming the above job sample from the Bostomatic which uses G39's >> codes to the Hurco. >> My question is...does the Fanuc OM Series control have any way of >> programming cutter diameter in the code? >> Thanks > >Micheal: >Yes, I believe there is. You will need to see if you can read and write to >variable #2002. >The tool length offset is #2001, or H1, and the diameter, or radius ofset is >#2002 or D2. >I have not used a 0M for some years, and the variable numbers may be >different. It works on a Fanuc 16. I am not sure if you need to have macro B >turned on or if it works without an option. >A macro statement like this may work: >#2002=.500(SET INITIAL SIZE) >#2002=[#2002+.003]( A VALUE IS CHANGED IN THE CODE) >G1G41D2(TURN ON CUTTER COMP) > >You might also check out http://www.programmingunlimited.com there are some >good macro examples there for many different controls. >Enjoy! > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
